Amica PH6400Z Manuel d'instructions télécharger pdf (Page 12)

Fix the mains connection cable in a stay wire

INSTALLATION

Before connecting the plate to the electric system read information provided on the rating

plate and wiring diagram.

Note!

The installer is obliged to complete and leave with the user a “certicate of connecting the

plate to the mains” (attached to the warranty card).

Methods of connection other than those indicated on the diagram can damage the plate.

Connecting the plate to the electrical system

Note!

The plate can be connected to the mains only by a qualied certied installer. Wilful

adaptations or modications to the electric system are prohibited.

Guidelines for the installer

The plate is factory-set for three-phase alternating current power supply (400 V 2N~50 Hz).

It may be adapted for one-phase current power supply (230 V) by adequate bridging on the

connection strip, in accordance with the attached wiring diagram. The wiring diagram is also

provided in the bottom part of the lower cover. The connection strip can be accessed once

the lid on the bottom cover is removed. Please remember to match the mains connection

cable to the type of connection and the rated power of the plate.

Note!

Do not forget to connect the protective circuit to a clamp of the connection strip marked

with sign. The plate power supply system should be protected by appropriately

selected safety device or after the power supply protection, by appropriate safety

switch cutting off the power in case of emergency.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Amica PH6400Z Manuel d'instructions Page 12